Acura ILX Forums banner

Skunk2 shift knob

2718 Views 1 Reply 2 Participants Last post by  g0tph0
Had my Skunk2 shift knob from my Civic Si laying around so decided to put it in yesterday, looks ok to me, just wish it sat lower, I was unable to fully remove the collar so I could screw it all the way down. Is there a DIY on removing it? I didn't want to rip the boot trying to get it off
See less See more
1 - 2 of 2 Posts
that plastic ring will pop down with force. i know what i just said sounds scary but once it pops down use a wrench then youre good to remove it. i have the same knob and i want it to sit lower too but only way to do that is actually to cut the threads.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.