Acura ILX Forums banner

Rear 'A' Emblem

1926 Views 4 Replies 4 Participants Last post by  ilxluv
Hello all...

Unfortunately, I had the privelage of some dude's shopping cart scratching the paint within the rear 'A' emblem on the trunklid and damaging the emblem itself. I was considering just removing the damaged emblem and replacing it with a red or white aftermarket 'A' emblem to temporarily cover the damage. The height of the OEM emblem is around 4 1/4 inches (11cm). Is there a universal fit application out there in that size that would do the trick? I'm having a hard time finding one that will work.

Thank you.
1 - 5 of 5 Posts
The way the trunk lid curves you'd have to go OEM at this point, unless you get creative.
OE is probably the only way like trentimus said.

If you get the emblem off, or if you already know, see if the A emblem has two prongs that hold it to the trunk or if its just adhesive... Please and thanks!
OE is probably the only way like trentimus said.

If you get the emblem off, or if you already know, see if the A emblem has two prongs that hold it to the trunk or if its just adhesive... Please and thanks!
it has two prongs as well as adhesive. I just got one in the mail that I will be painting and putting on at sone point.
  • Like
Reactions: 1
Thank you!!! This was literally the first post I made; asking about those prongs. I think I may take my ILX emblem off tomorrow. Not sure yet if Ill have time.
  • Like
Reactions: 2
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top