Acura ILX Forums banner
1 - 6 of 6 Posts

· Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
9th Gen Civic Si Invidia Q300 catback. Bolts up fine. A 98% match for the ILX but the shop had to heat the pipe before the muffler and pull at the tip to get the exhaust tip perfectly on center (the tip was pulling towards drivers side and rubbing the valence). I had an idea something like this would be the case- this is why I didn’t bolt it up myself.

Sounds great. Throaty and performance sounding with some pops when letting off the gas. Not loud or annoying. No drone.

Car Tire Land vehicle Wheel Vehicle

Tire Wheel Vehicle Automotive tire Automotive lighting

Wheel Vehicle registration plate Car Vehicle Tire

Automotive lighting Hood Automotive tire Car Automotive design

Automotive parking light Tire Wheel Automotive lighting Automotive tire

Wheel Tire Car Vehicle Land vehicle

Tire Wheel Car Vehicle Automotive tire
 

· Registered
Joined
·
13 Posts
Discussion Starter · #3 ·
Looks great 👍👍👍👍👍👍👍

Do you have more information to get it online? Exact model or link to a page

Regards
Sure!
SKU is HS12HC4G3S
I got it from Emnotek

 

· Registered
Joined
·
13 Posts
Discussion Starter · #4 ·
Of note!
A) An exhaust place will probably have to heat and the pipe before the muffler and pull the tip towards center of the bumper cutout for correct alignment.

B) If your car is lowered, the Invidia catback midpipe is known to droop a little low- will scrape on steep ramp and curb cut transitions. It’s already happened on my car as I’ve entered a parking garage with a steep ramp, but given the sound quality (not loud) and performance (it’s actually a bit more responsive on throttle tip in) I was looking for, I’m ok with it.

Automotive parking light Car Automotive tire Automotive lighting Tire
 

· Registered
Joined
·
41 Posts
9th Gen Civic Si Invidia Q300 catback. Bolts up fine. A 98% match for the ILX but the shop had to heat the pipe before the muffler and pull at the tip to get the exhaust tip perfectly on center (the tip was pulling towards drivers side and rubbing the valence). I had an idea something like this would be the case- this is why I didn’t bolt it up myself.

Sounds great. Throaty and performance sounding with some pops when letting off the gas. Not loud or annoying. No drone.

View attachment 2624
View attachment 2628
View attachment 2626
View attachment 2623
View attachment 2629
View attachment 2627
View attachment 2625
looks great man and send me the vin number will collect the all the information of the car trough VIn Decoder
 
1 - 6 of 6 Posts
Top